Node
- Parent node
- Child nodes
AC2200
* You can't connect more than three nodes to a Velop mesh
LED
- Purple: Ready for setup
- Blue: Connected to internet
- Red: No internet
- Yellow/Orange: Signal is weak
Blinking
- Purple: Setup in progress
- Blue: Powering on
- Red: Node has lost connection to the primary node
HW:
- 6 條內部天線
- 802.11ac
- 三頻 (2.4Ghz + 5GHz + 5GHz)
- 2 個 Gigabit WAN/LAN
- AP/橋接模式
- 12V, 2A
AC2200 Setup
1) 手機安 App
2) 插電等 LED 轉 Purple
3) App 內啟動產品(藍牙)
i 按提示等佢 LED 閃 Purple
ii 連佢預設 Wifi 再進行最後設定
Reset
Press and hold the reset button at the bottom of the device.
The light on top of the parent node will turn red and fade in three pulses.
Do not release the button until the light goes out and then turns bright red.
After you reset and reconfigure the parent node,
all child nodes will no longer be part of your Velop network.
Once you're done resetting the parent node, perform the same steps above on each child node.