Dell H710

Default: SAS

The H710 is backwards compatible with SATA

You can't mix SAS and SATA within a virtual disk.

Software: megacli

https://datahunter.org/megacli

Adaptec

HomePage: http://storage.microsemi.com/en-us/support/raid/

lspci | grep RAID

01:01.0 RAID bus controller: Adaptec AAC-RAID (rev 01)

lspci | less

01:01.0 RAID bus controller: Adaptec AAC-RAID (rev 01)
        Subsystem: Adaptec AAR-2810SA PCI SATA 8ch (Corsair-8)
        Flags: bus master, 66MHz, slow devsel, latency 32, IRQ 22
        Memory at f0000000 (32-bit, prefetchable) [size=64M]
        Expansion ROM at ff910000 [disabled] [size=32K]
        Capabilities: [80] Power Management version 2
        Kernel driver in use: aacraid
        Kernel modules: aacraid

Hardware info: http://storage.microsemi.com/en-us/support/raid/sata/aar-2810sa/

Adaptec Storage Manager for Linux.

ASM (Adaptec Storage Manager)

arcconf getconfig 1

Controllers found: 1

----------------------------------------------------------------------
Controller information
----------------------------------------------------------------------
   Controller Status                   : Optimal
   Channel description                 : SATA
   Controller Model                    : Adaptec 2810SA
   Controller Serial Number            : C695E4
   Physical Slot                       : 2
   Installed memory                    : 64 MB
   Copyback                            : Disabled
   Background consistency check        : Disabled
   Defunct disk drive count            : 0
   Logical devices/Failed/Degraded     : 1/0/0
   ---------------------------------------------------
   Controller Version Information
   ---------------------------------------------------
   BIOS                                : 4.2-0 (7348)
   Firmware                            : 4.2-0 (7348)
   Driver                              : 1.2-0 (29801)
   Boot Flash                          : 0.0-0 (0)
   ---------------------------------------------------
   Controller Battery Information
   ---------------------------------------------------
   Status                              : Not Installed

# Adapter information

arcconf GETCONFIG 1 AD

# Logical device information

arcconf GETCONFIG 1 LD

# Physical device information

arcconf GETCONFIG 1 PD